A few tips for mechanical design โ๏ธ
What's on the table this time?
This is a part of a sheet-metal rolling and bending line I once designed.ย
This specific part performs a single stamping operation,
but that's not the main focus here.
What did I highlight for you?
๐ข Green - Reinforce the structure as much as possible! Even if your analysis shows a safety factor of 5, why not add a maximum-size reinforcement rib?
๐ต Blue - Connection plates, or as I call it, "Auxillary setup" โ trust me, no matter how many optional clamping points you add, you'll end up using all of them.
๐ก Yellow - Floor anchoring with leveling mechanisms โ this is especially important when aligning different modules along the production line, just like in this case.
Comments